Search for this SSID in the network settings of your device.Note: The SSID is derived from the MAC address, unique to each W1, and can be found on the bottom label. The network name (SSID) is similar to AJ_9C_65_F9_13_0A_C5 as can be seen in the picture to the right. The Nautical W1 will be visible when searching for WiFi networks.This may be a PC, Notebook, Smartphone, Tablet, or any other device with WiFi and a web browser. The Nautical W1 will by default start as a Soft AP (Software Access Point) and is visible to any WiFi-capable device. If you use a different device the appearance may differ slightly. The exhibits in this manual refer to a PC running a Windows operating system. Nauticast B2) RX A (-) TX A (-), green RX B (+) TX B (+), yellow TX A (-) RX A (-), grey TX B (+) RX B (+), white The transmitting wires of one device need to be connected to the receiving pins of a second device and vice versa in the following table: Device 1 (e.g. These are often referred to as TX A (or TX -) and TX B (or TX +) for the transmitting wires and RX A (or RX -) and RX B (or RX +) for the receiving wires. RS422/RS485 uses 2 wires to transmit information and 2 wires to receive. To connect an RS422/RS485 device no standard plugs are defined but 4 terminal sockets are used. Interface speeds up to 115200 Baud are supported.
The Nautical W1 has a standard RS232 9pin D-Sub socket, where you can connect any standard RS232 cable. Only one of the 2 ports can be used at the same time.
#Memory clean 3 seriel serial#
Optional: connect a device (like the Nauticast B2) to the serial interface either to RS232 or to RS422 (as marked on the device).Alternatively, there is a direct cable connection for a 2 wire power cable (9-24V DC). The connector at the other end of the cable needs to be connected to the W1 power socket. Power up the W1: connect the power cable to a 9-24V DC power source or the 100-230V AC power supply to a 100-230V AC plug.Screw the Wifi antenna into the connection thread. Optional: 100-240V AC power supply(included in p/n 300 2002).O + other Documentation and Information Material O WiFi Module Utility (software for Windows) Documentation and Software USB memory containing:.
#Memory clean 3 seriel manuals#
7.2 Related Manuals / Resources Installationīefore proceeding with the installation of the Nauticast W1 please check the contents of the box, which include:
0 kommentar(er)
